Page 3/3

27January2016/version 12

LEM reserves the right to carry out modifications on its transducers, in order to improve them, without prior notice

www.lem.com

Mechanical characteristics

● General tolerance

±0.2 mm

● Primary through-hole

12.7 × 7 mm

● Fastening & Connection of secondary 3 pins

0.6 × 0.7 mm

● Recommended PCB hole

⌀ 1.2 mm

Remarks

● I

● Temperature of the primary conductor should not exceed

100 °C.

● Dynamic performances (di/dt and response time) are best

with a single bar completely filling the primary hole.

● Installation of the transducer must be done unless

otherwise specified on the datasheet, according to LEM

Transducer Generic Mounting Rules. Please refer to

LEM document N°ANE120504 available on our Web site:

● In order to achieve the best magnetic coupling, the

primary windings have to be wound over the top edge of

the device.

● This is a standard model. For different versions (supply

voltages, turns ratios, unidirectional measurements...),

please contact us.

d

Cl

d

Cp

d

Cl

d

Cp

Connection

d

Cl

d

Cp