数据搜索系统,热门电子元器件搜索 |
|
5--21012--4 数据表(PDF) 2 Page - Tyco Electronics |
|
5--21012--4 数据表(HTML) 2 Page - Tyco Electronics |
2 / 4 page 408- 4040 0.8mm CHAMP Crimper Assemblies 122842- 1, 122842- 2, and 122842- 3 Rev C 2 of 4 Tyco Electronics Corporation 3.1. Lower Tooling Assembly 1. Remove the tool stop from the slide base of the arbor frame assembly. 2. Slide the lower tooling assembly into the tracks of the frame assembly slide base. The cable clamp spring must be oriented to the left side of the slide base as shown in Figure 1. 3. Re--install the tool stop and secure it with the socket head cap screw. 3.2. Upper Tooling Assembly 1. Remove the upper tool mount (supplied with the arbor frame assembly) by removing the two flat head cap screws. Do not discard this tool mount. 2. Install the tool mount (supplied with the crimper assembly) to the ram of the arbor frame assembly and secure it with the flat head cap screws. 3. Position the crimper in the tool mount with the longer offset to the right (as shown in Figure 1). Secure crimper to tool mount with the socket head cap screw. 4. TOOLING ADJUSTMENTS The following adjustments are required during the initial setup of the crimper assembly and when changing cable size. 4.1. Cable Clamp Springs The cable clamp springs can be adjusted for various cable diameters by loosening the socket head cap screws and re--positioning the cable clamp springs. 4.2. Crimp Height To check crimp height, a test crimp should be made (refer to Section 5); then, measure the crimp height of the backshell ferrule. Refer to the appropriate application specification (114--series) for the crimp height. If the actual crimp height does not conform to that dimension, proceed as follow: 1. Loosen the setscrew on the adjustment ring. Turn the adjustment ring CLOCKWISE to increase crimp height or COUNTERCLOCKWISE to decrease crimp height. 2. Re--tighten the setscrew. 5. CRIMPING PROCEDURE Refer to Figure 2 and proceed as follows: 1. Using the ball handle, slide the lower tooling assembly out from under the ram of arbor frame assembly. 2. Position the connector backshell assembly in the support block. Figure 2 Adjustment Ring Handle Ram Connector Lower Tooling Assembly Support Block Tool Stop Ball Handle Cable Cable Clamp Spring Rear Tool Stop |
类似零件编号 - 5--21012--4 |
|
类似说明 - 5--21012--4 |
|
|
链接网址 |
隐私政策 |
ALLDATASHEETCN.COM |
ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |