ML15.051

MiniLine-2

Page

Page

1.

Intended Use .......................................................3

2.

Installation Requirements...................................3

3.

AC-Input...............................................................4

4.

DC-Input...............................................................5

5.

Input Inrush Current ...........................................5

6.

Output .................................................................6

7.

Hold-up Time.......................................................7

8.

Efficiency and Power Losses................................8

9.

Functional Diagram.............................................9

10. Front Side and User Elements.............................9

11. Terminals and Wiring........................................10

12. Lifetime Expectancy and MTBF.........................10

13. EMC....................................................................11

14. Environment ......................................................12

15. Protection Features ...........................................13

16. Safety Features ..................................................13

17. Dielectric Strength ............................................14

18. Approvals .......................................................... 15

19. Fulfilled Standards............................................ 15

20. Physical Dimensions and Weight ..................... 16

21. Application Notes............................................. 17

21.1. Peak Current Capability ...........................17

21.2. Back-feeding Loads ..................................17

21.3. External Input Protection.........................18

21.4. Parallel Use to Increase Output Power....18

21.5. Parallel Use for Redundancy ....................19

21.6. Series Operation .......................................19

21.7. Inductive and Capacitive Loads................19

21.8. Operation on Two Phases ........................20

21.9. Use Without PE on the Input ...................20

21.10. Use in a Tightly Sealed Enclosure ............21

21.11. Mounting Orientations ............................22

The information presented in this document is believed to be accurate and reliable and may change without notice.

The housing is patent by PULS (US patent No US D442,923S)

No part of this document may be reproduced or utilized in any form without permission in writing from the publisher.

PE and

symbol

PE is the abbreviation for Protective Earth and has the same meaning as the symbol

.

Earth, Ground

This document uses the term “earth” which is the same as the U.S. term “ground”.

T.b.d.

To be defined, value or description will follow later.

AC 230V

A figure displayed with the AC or DC before the value represents a nominal voltage with

standard tolerances (usually ±15%) included.

E.g.: DC 12V describes a 12V battery disregarding whether it is full (13.7V) or flat (10V)

230Vac

A figure with the unit (Vac) at the end is a momentary figure without any additional

tolerances included.

50Hz vs. 60Hz

As long as not otherwise stated, AC 100V and AC 230V parameters are valid at 50Hz and AC

120V parameters are valid at 60Hz mains frequency.

Mar. 2013 / Rev. 2.1 DS-ML15.051-EN

All parameters are specified at 5V, 3A, 230Vac input, 25°C ambient and after a 5 minutes run-in time unless otherwise noted.

www.pulspower.com Phone +49 89 9278 0

Germany

2/22