DSC400-0224Q0001KE2T datasheet(5/20 Pages) MICROCHIP

部件名	DSC400-0224Q0001KE2T

功能描述	Configurable Four Output, Low Jitter Crystal-less??Clock Generator

Download	20 Pages

Scroll/Zoom	100%

制造商	MICROCHIP [Microchip Technology]

网页	http://www.microchip.com

标志

5 / 20 page

 2016 Microchip Technology Inc.

DS20005612A-page 5

DSC400

3.0

OPERATIONAL DESCRIPTION

The DSC400 is a crystal-less™ clock generator. Unlike

older clock generators in the industry, it does not

require an external crystal to operate; it relies on the

integrated MEMS resonator that interfaces with internal

PLLs. This technology enhances performance and

reliability by allowing tighter frequency stability over a

far wider temperature range. In addition, the higher

resistance to shock and vibration decreases the aging

rate to allow for much improved product life in the

system.

3.1

Inputs

There are four input signals in the device. Each has an

internal (40 kΩ) pull-up to default the selection to a high

(1). Inputs can be controlled through hardware

strapping method with a resistor to ground to assert the

input low (0). Inputs may also be controlled by other

components’ GPIOs

In case more than one frequency set is desired, FSB1

and FSB2 are used to independently select one of two

sets per bank. FSB1 selects the pre-configured set on

Bank1 (CLK0 and CLK3) and FSB2 selects the

pre-configured set on Bank2 (CLK1 and CLK2), as

shown in Table 1-1 in the Product Identification System

section.

If there is a requirement to disable outputs, the inputs

OE1 and OE2 are used in conjunction to disable the

banks of outputs. Outputs are disabled in tri-state (Hi-Z)

mode. See Table 3-1 for more information.

3.2

Outputs

The four outputs are grouped into two banks. Each

bank is supplied by an independent VDD to allow for

optimized noise isolation between the two banks. Each

bank provides two synchronous outputs generated by

a common PLL:

• Bank1 is composed of outputs CLK0 and CLK3.

• Bank2 is composed of outputs CLK1 and CLK2.

Each output may be pre-configured independently to

be one of the following formats: LVCMOS, LVDS,

LVPECL or HCSL. In case the output is configured to

be single-ended LVCMOS, the frequency is generated

on the true output (CLKx+) and the complement output

(CLKx–) is shut off in a low state. Frequencies can be

chosen from 2.3 MHz to 460 MHz for differential

outputs and from 2.3 MHz to 170 MHz on LVCMOS

outputs.

3.3

Power

VDD1 and VDD2 supply the power to banks 1 and 2

respectively. Each VDD may each have a different

supply voltage from the other as long as it is within the

2.25V to 3.6V range. Each VDD pin should have a

0.1 µF capacitor to filter high-frequency noise. VSS is

common to the entire device.

TABLE 3-1:

OUTPUT ENABLE

SELECTION TABLE

OE1

OE2

Bank 1

(CLK0 & CLK3)

Bank 2

(CLK1 & CLK2)

0

Hi-Z

0

1

Hi-Z

Running

1

0

Running

Hi-Z

1

Running

类似零件编号 - DSC400-0224Q0001KE2T

制造商	部件名	数据表	功能描述
Micrel Semiconductor	DSC400-0224Q0001KE2T	456Kb / 15P	Configurable Four Output, Low Jitter Crystal-less??Clock Generator

More results

类似说明 - DSC400-0224Q0001KE2T

制造商	部件名	数据表	功能描述
Micrel Semiconductor	DSC400	456Kb / 15P	Configurable Four Output, Low Jitter Crystal-less??Clock Generator
Microchip Technology	DSA400	889Kb / 20P	Configurable Four Output, Low Jitter Clock Generator for Automotive 02/28/20
Micrel Semiconductor	DSC2311	632Kb / 5P	Crystal-less??Configurable Two Output Clock Generator
Microchip Technology	DSC2311	228Kb / 18P	Crystal-less??Configurable Two-Output Clock Generator 06/23/16
Micrel Semiconductor	DSC2311KM1-R0036	573Kb / 5P	Crystal-less??Configurable Clock Generator
	DSC2011FI2-F0016	594Kb / 6P	Crystal-less??Configurable Clock Generator
	DSC2010FE2-B0008	591Kb / 6P	Crystal-less??Configurable Clock Generator
	DSC2010FE2-B0003	591Kb / 6P	Crystal-less??Configurable Clock Generator
	DSC2311KI2-R0045	573Kb / 5P	Crystal-less??Configurable Clock Generator
Microchip Technology	DSC2123FI2-E0024	1Mb / 7P	Crystal-less??Configurable Clock Generator November 01, 2017 Revision 1.0