10 | Keysight | CX3300 Series Device Current Waveform Analyzer - Data Sheet

Automatic Power and Current Profiler can eliminate time-consuming

power and current profile analysis.

Analysis of power or current profile is essential in order to know how much current is

consumed at a certain event or status, but it is time-consuming process. This profiler

automatically draws lines in the time scale by the vertical level difference and instantly

calculates key parameters such as average current, max./min. current, accumulated

charge, etc. for each segment in the adjacent table. You can also manually adjust the

segment according to your measured profile.

Executing user calibration before a measurement ensures that you can

make full use of the CX3300’s superior performance.

For low-level current measurements it is important to set “zero current” level before the

measurement. The CX3300 series mainframe features easy-to-use calibration capability

including mainframe and a current sensor connected. It can also calibrate with a passive

probe for more accurate dynamic power measurements.

An upgradable mainframe allows you to purchase the current most

affordable CX3300 series without sacrificing future measurement needs.

The CX3300 mainframe has the following options, allowing you to choose the best

specifications according to your budget and application needs.

– Three maximum bandwidth options: 50 MHz, 100 MHz and 200 MHz

– Three memory depth options per channel: 16 Mpts, 64 Mpts and 256 Mpts

These upgrade license products are available for you to easily and quickly enhance the

bandwidth and the memory depth of the mainframe that you have previously purchased.

Please see the “CX3300 Series Configuration Guide” in detail.

1. Number of channels is not upgradable.

Figures 20a and 20b. Automatic Power and Current Profiler (20a) and the report table (20b)

Figure 21. Aux Out is used in the calibration

procedure for each channel by connecting the

sensors and probe adapter. As the connection

cable is included in the mainframe, you can

immediately start the User Calibration.

(20a)

(20b)