GS81314LD19/37GK-933/800

Specifications cited are subject to change without notice. For latest documentation see http://www.gsitechnology.com.

Rev: 1.02 3/2016

11/39

© 2015, GSI Technology

Register Write Mode Utilization - Synchronous Method

Register Write Mode can also be utilized synchronously up to the full operating speed of the device. However, MRW cannot be

trained using Loopback Mode, so the ability to use it synchronously may be limited to slower operating frequencies where the lack

of training capability is less problematic for the user.

In this case, MRW, R, W, and SA[10:1] are all driven synchronously (i.e. they all meet setup and hold time specs to

CK). When

Register Write Mode is utilized in this manner, multiple registers can be programmed in successive cycles. The timing diagrams

below arbitrarily show four registers programmed in successive cycles, but in practice it can be any number greater than or equal to

one.

The requirements for this usage case are as follows:

• At least 16 NOPs must be initiated before and after the Register Write(s).

• MRW must be driven High (synchronously), R must be driven Low (synchronously), and SA[10:1] must be driven Valid (syn-

chronously) for each Register Write.

• W state is a “don’t care” (synchronously) for each Register Write.

Synchronous Register Write Timing Diagram

CK

SA[10:1]

W

Register Write Mode

16 NOPs

Read / Write

Read / Write

16 NOPs

Reg #d

Reg #a

MRW

Reg #b

Reg #c

R

X

X

X

X

V

V

V

V

V

V

V

V

V