Package Dimension

NOTES:

1. ALL DIMENSIONS ARE IN MILLIMETERS (INCHES).

2. TAPERS SHOWN AT TOP OF LEADS (BOTTOM OF LAMP PACKAGE) INDICATE AN

EPOXY MENISCUS THAT MAY EXTEND ABOUT 1 mm (0.040 in.) DOWN THE LEADS.

3. RECOMMENDED PC BOARD HOLE DIAMETERS:

- LAMP PACKAGE A WITHOUT STAND-OFFS: FLUSH MOUNTING AT BASE OF

LAMP PACKAGE = 1.143/1.067 (0.044/0.042).

- LAMP PACKAGE B WITH STAND-OFFS: MOUNTING AT LEAD STAND-OFFS

= 0.965/0.889 (0.038/0.035).

4. FOR DOME HEIGHTS ABOVE LEAD STAND-OFF SEATING PLANE, d, LAMP PACKAGE B, SEE TABLE.

B

A

1.14 ± 0.20

(0.045 ±� 0.008)

5.80 ± 0.20

(0.228 ± 0.008)

5.00 ± 0.20

(0.197 ±� 0.008)

31.60

(1.244) MIN.

0.70 (0.028)

MAX.

1.00

(0.039)

MIN.

8.71 ± 0.20

(0.343 ± 0.008)

2.54 ± 0.38

(0.100 ± 0.015)

0.50 ± 0.10

(0.020 ± 0.004) SQ. TYP.

CATHODE

LEAD

2.35 (0.093)

MAX.

CATHODE

FLAT

1.14 ± 0.20

(0.045 ± 0.008)

5.80 ± 0.20

(0.228 ± 0.008)

5.00 ± 0.20

(0.197 ± 0.008)

31.60

(1.244) MIN.

0.70 (0.028)

MAX.

1.00

(0.039)

MIN.

8.71 ± 0.20

(0.343 ± 0.008)

2.54 ± 0.38

(0.100 ± 0.015)

0.50 ± 0.10

(0.020 ± 0.004) SQ. TYP.

CATHODE

LEAD

CATHODE

FLAT

d

1.50 ± 0.15

(0.059 ± 0.006)

PART NO.

d

HLMP-XX13

12.42 ± 0.25

(0.489 ± 0.010)

HLMP-XX23

11.59 ± 0.25

(0.446 ± 0.010)

HLMP-XX37

11.96 ± 0.25

(0.471 ± 0.010)

5. FOR IDENTIFICATION OF POLARITY AFTER THE LEADS ARE TRIMMED OFF, PLEASE REFER TO THE ILLUSTRATION BELOW:

7. MAJOR HEAT PATH IS THROUGH THE ANODE LEAD

CATHODE

ANODE