数据搜索系统,热门电子元器件搜索 |
|
HCPL-2200-300E 数据表(PDF) 10 Page - AVAGO TECHNOLOGIES LIMITED |
|
HCPL-2200-300E 数据表(HTML) 10 Page - AVAGO TECHNOLOGIES LIMITED |
10 / 13 page 10 IF (ON) 50 % IF (ON) 0 mA tPLH tPHL VOH 1.3 V VOL INPUT IF OUTPUT VO Figure 2. Typical logic high output current vs. temperature. Figure 3. Output voltage vs. forward input current. Figure 4. Typical input diode forward characteristic. Figure 1. Typical logic low output voltage vs. temperature. Notes: 1. Derate total package power dissipation, PT, linearly above 70 °C free air temperature at a rate of 4.5 mW/ °C. 2. Duration of output short circuit time should not exceed 10 ms. 3. Device considered a two-terminal device: pins 1, 2, 3, and 4 shorted together and pins 5, 6, 7, and 8 shorted together. 4. The tPLH propagation delay is measured from the 50% point on the leading edge of the input pulse to the 1.3 V point on the leading edge of the output pulse. The tPHL propagation delay is measured from the 50% point on the trailing edge of the input pulse to the 1.3 V point on the trailing edge of the output pulse. 5. When the peaking capacitor is omitted, propagation delay times may increase by 100 ns. 6. CML is the maximum rate of rise of the common mode voltage that can be sustained with the output voltage in the logic low state (VO < 0.8 V). CMH is the maximum rate of fall of the common mode voltage that can be sustained with the output voltage in the logic high state (VO > 2.0 V). -60 -8 TA – TEMPERATURE – °C 100 0 -20 -5 20 60 -40 0 40 80 -3 -1 -6 VCC = 4.5 V IF = 5 mA -7 -4 -2 VO = 2.7 V VO = 2.4 V 1.1 0.001 VF – FORWARD VOLTAGE – V 1.0 1000 1.3 0.01 1.5 1.2 1.4 0.1 TA = 25 °C 10 100 IF + – VF 7. Use of a 0.1 µF bypass capacitor connected between pins 5 and 8 is recommended. 8. In accordance with UL1577, each optocoupler is proof tested by applying an insulation test voltage ≥4500 V rms for one second (leakage detection current limit, II-O ≤5 µA). This test is performed before the 100% production test for partial discharge (Method b) shown in the IEC/EN/DIN EN 60747-5-2 Insulation Characteristics Table, if applicable. Figure 5. Test circuit for tPLH, tPHL, tr, and tf. -60 0 TA – TEMPERATURE – °C 100 1.0 -20 0.4 20 60 -40 0 40 80 0.6 0.8 0.2 VCC = 4.5 V IF = 0 mA VO = 6.4 mA 0.1 0.3 0.5 0.7 0.9 0 0 IF – INPUT CURRENT – mA 2.0 5 2 1.0 0.5 3 1 4 IOL = 6.4 mA IOH = -2.6 mA 1.5 VCC = 4.5 V TA = 25 °C 7 1 4 5 6 8 HCPL-2200 GND VCC 5 V 619 Ω INPUT MONITORING NODE PULSE GEN. tr = tf = 5 ns f = 100 kHz 10 % DUTY CYCLE VO = 5 V C2 = 15 pF THE PROBE AND JIG CAPACITANCES ARE INCLUDED IN C1 AND C2. OUTPUT VO MONITORING NODE VCC R1 D1 D2 5 k Ω D3 D4 2 3 C1 = 120 pF RI IF (ON) 2.15 k Ω 1.6 mA 1.10 k Ω 3 mA 681 Ω 5 mA ALL DIODES ARE 1N916 OR 1N3064. IF |
类似零件编号 - HCPL-2200-300E |
|
类似说明 - HCPL-2200-300E |
|
|
链接网址 |
隐私政策 |
ALLDATASHEETCN.COM |
ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |