数据搜索系统,热门电子元器件搜索 |
|
CBC3105-R4C 数据表(PDF) 9 Page - Cymbet Corporation |
|
CBC3105-R4C 数据表(HTML) 9 Page - Cymbet Corporation |
9 / 12 page EnerChip CC CBC3105 ©2012 Cymbet Corporation • Tel: +1-763-633-1780 • www.cymbet.com DS-72-21 Rev E Page 9 of 12 Preliminary EnerChip CC Detailed Description The EnerChip CC uses a charge pump to generate the supply voltage for charging the integrated energy storage device. An internal FET switch with low RDSON is used to route VDD to VOUT during normal operation when main power is above the switchover threshold voltage. When VDD is below the switchover threshold voltage, the FET switch is shut off and VOUT is supplied by the EnerChip. An interrupt signal is asserted low prior to the switchover. Operating Modes The EnerChip CC can be operated from various power supplies such as a primary source or a non-rechargeable battery. With the ENABLE pin asserted high, the charge pump is active and charges the integrated EnerChip. The EnerChip CC will be 80% charged within 10 minutes. Due to the rapid recharge it is recommended that, once the EnerChip CC is fully charged, the user de-assert the ENABLE pin (i.e., force low) to reduce power consumption. A signal generated from the MCU could be used to enable and disable the EnerChip CC. When controlling the ENABLE pin by way of an external controller - as opposed to fixing the ENABLE line to VDD - ensure that the ENABLE pin is forced low by the controller anytime the RESET line is low, which occurs when the switchover threshold voltage is reached and the device is placed in backup mode. Although the internal charge pump is designed to operate below the threshold switchover level when the ENABLE line is active, it is recommended that the ENABLE pin be forced low whenever RESET is low to ensure no parasitic loads are placed on the EnerChip while in this mode. If ENABLE is high or floating while VDD is in an indeterminate state, bias currents within the EnerChip CC could flow, placing a parasitic load on the EnerChip that could dramatically reduce the effective backup operating time. The EnerChip CC supports 2 operational modes as shown in Figures 6 and 7. Mode 1 Operation For use in 3.3 volt systems. The VMODE pin should be tied directly to GND, as shown in Figure 6. This will set the switchover threshold at approximately 3.0 volts. Figure 6: CBC3105 Typical Circuit for Mode 1 Operation |
类似零件编号 - CBC3105-R4C |
|
类似说明 - CBC3105-R4C |
|
|
链接网址 |
隐私政策 |
ALLDATASHEETCN.COM |
ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |