数据搜索系统,热门电子元器件搜索 |
|
HCPL-7720 数据表(PDF) 11 Page - AVAGO TECHNOLOGIES LIMITED |
|
HCPL-7720 数据表(HTML) 11 Page - AVAGO TECHNOLOGIES LIMITED |
11 / 18 page 11 Figure 13. Propagation delay skew waveform. Figure 14. Parallel data transmission example. Propagation delay skew represents the uncertainty of where an edge might be after being sent through an op- tocoupler. Figure 14 shows that there will be uncertainty in both the data and clock lines. It is important that these two areas of uncertainty not overlap, otherwise the clock signal might arrive before all of the data outputs have settled, or some of the data outputs may start to change before the clock signal has arrived. From these consider- ations,theabsoluteminimumpulsewidththatcanbesent throughoptocouplersinaparallelapplicationistwicetPSK. Pulse-width distortion (PWD) is the difference between tPHL and tPLH and often determines the maximum data rate capability of a transmission system. PWD can be expressed in percent by dividing the PWD (in ns) by the minimum pulse width (in ns) being transmitted. Typical- ly, PWD on the order of 20 - 30% of the minimum pulse width is tolerable. Propagation delay skew, tPSK, is an important parameter to consider in parallel data applications where synchro- nization of signals on parallel data lines is a concern. If the parallel data is being sent through a group of opto- couplers, differences in propagation delays will cause the data to arrive at the outputs of the optocouplers at differ- ent times. If this difference in propagation delay is large enough it will determine the maximum rate at which parallel data can be sent through the optocouplers. Propagation delay skew is defined as the difference be- tween the minimum and maximum propagation delays, either tPLH or tPHL, for any given group of optocouplers which are operating under the same conditions (i.e., the same drive current, supply voltage, output load, and op- erating temperature). As illustrated in Figure 13, if the in- puts of a group of optocouplers are switched either ON or OFF at the same time, tPSK is the difference between the shortest propagation delay, either tPLH or tPHL, and the longest propagation delay, either tPLH or tPHL. As mentioned earlier, tPSK can determine the maximum parallel data transmission rate. Figure 14 is the timing diagram of a typical parallel data application with both the clock and data lines being sent through the opto- couplers. The figure shows data and clock signals at the inputs and outputs of the optocouplers. In this case the data is assumed to be clocked off of the rising edge of the clock. A cautious design should use a slightly longer pulse width to ensure that any additional uncertainty in the rest of the circuit does not cause a problem. The HCPL-772X/072X optocouplers offer the advantage of guaranteed specifications for propagation delays, pulse-width distortion, and propagation delay skew over the recommended temperature and power supply ranges. 50% 50% tPSK VI VO VI VO 2.5 V, CMOS 2.5 V, CMOS DATA INPUTS CLOCK DATA OUTPUTS CLOCK tPSK tPSK |
类似零件编号 - HCPL-7720 |
|
类似说明 - HCPL-7720 |
|
|
链接网址 |
隐私政策 |
ALLDATASHEETCN.COM |
ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |