SI1141 datasheet(8/66 Pages) SILABS

部件名	SI1141

功能描述	PROXIMITY/AMBIENT LIGHT SENSOR IC WITH I2C INTERFACE

Download	66 Pages

Scroll/Zoom	100%

制造商	SILABS [Silicon Laboratories]

网页	http://www.silabs.com

标志

8 / 66 page

Si1141/42/43

8

Preliminary Rev. 0.5

2. Functional Description

2.1. Introduction

The Si1141/42/43 is an active optical reflectance proximity detector and ambient light sensor whose operational

state is controlled through registers accessible through the I2C interface. The host can command the Si1141/42/43

to initiate on-demand proximity detection or ambient light sensing. The host can also place the Si1141/42/43 in an

autonomous operational state where it performs measurements at set intervals and interrupts the host either after

each measurement is completed or whenever a set threshold has been crossed. This results in an overall system

power saving allowing the host controller to operate longer in its sleep state instead of polling the Si1141/42/43. For

more details, refer to “AN498: Designer's Guide for the Si114x”.

2.2. Proximity Sensing (PS)

The Si1141/42/43 has been optimized for use as either a dual-port or single-port active reflection proximity

detector. Over distances of less than 50 cm, the dual-port active reflection proximity detector has significant

advantages over single-port, motion-based infrared systems, which are only good for triggered events. Motion-

based infrared detectors identify objects within proximity, but only if they are moving. Single-port motion-based

infrared systems are ambiguous about stationary objects even if they are within the proximity field. The Si1141/42/

43 can reliably detect an object entering or exiting a specified proximity field, even if the object is not moving or is

moving very slowly. However, beyond about 30–50 cm, even with good optical isolation, single-port signal

processing may be required due to static reflections from nearby objects, such as table tops, walls, etc. If motion

detection is acceptable, the Si1141/42/43 can achieve ranges of up to 50 cm, through a single product window.

For small objects, the drop in reflectance is as much as the fourth power of the distance. This means that there is

less range ambiguity than with passive motion-based devices. For example, a sixteenfold change in an object's

reflectance means only a fifty-percent drop in detection range.

The Si1141/42/43 can drive three separate infrared LEDs. When the three infrared LEDs are placed in an L-shaped

configuration, it is possible to triangulate an object within the three-dimensional proximity field. Thus, a touchless

user interface can be implemented with the aid of host software.

The Si1141/42/43 can initiate proximity sense measurements when explicitly commanded by the host or

periodically through an autonomous process. Refer to "3. Operational Modes" on page 14 for additional details of

the Si1141/42/43's Operational Modes.

Whenever it is time to make a PS measurement, the Si1141/42/43 makes up to three measurements, depending

on what is enabled in the CHLIST parameter. Other ADC parameters for these measurements can also be

modified to allow proper operation under different ambient light conditions.

The LED choice is programmable for each of these three measurements. By default, each measurement turns on a

single LED driver. However, the order of measurements can be easily reversed or even have all LEDs turned on at

the same time. Optionally, each proximity measurement can be compared against a host-programmable threshold.

With threshold settings for each PS channel, it is also possible for the Si1141/42/43 to notify the host whenever the

threshold has been crossed. This reduces the number of interrupts to the host, aiding in efficient software

algorithms.

The Si1141/42/43 can also generate an interrupt after a complete set of proximity measurements, ignoring any

threshold settings.

To support different power usage cases dynamically, the infrared LED current of each output is independently

programmable. The current can be programmed anywhere from a few to several hundred milliamps. Therefore, the

host can optimize for proximity detection performance or for power saving dynamically. This feature can be useful

since it allows the host to reduce the LED current once an object has entered a proximity sphere, and the object

can still be tracked at a lower current setting. Finally, the flexible current settings make it possible to control the

infrared LED currents with a controlled current sink, resulting in higher precision.

The ADC properties are programmable. For indoor operation, the ADC should be configured for low signal range

for best reflectance sensitivity. When under high ambient conditions, the ADC should be configured for high signal

level range operation.

类似零件编号 - SI1141

制造商	部件名	数据表	功能描述
Silicon Laboratories	SI1141-A11-GM	1Mb / 77P	PROXIMITY/AMBIENT LIGHT SENSOR IC WITH I 2C INTERFACE Rev. 1.42 3/21
	SI1141-A11-GMR	1Mb / 77P	PROXIMITY/AMBIENT LIGHT SENSOR IC WITH I 2C INTERFACE Rev. 1.42 3/21
	SI1141-A11-YM0R	1Mb / 77P	PROXIMITY/AMBIENT LIGHT SENSOR IC WITH I 2C INTERFACE Rev. 1.42 3/21
	SI1141-M01	1Mb / 79P	High reflectance sensitivity
	SI1141-M01-GM	1Mb / 79P	PROXIMITY/AMBIENT LIGHT SENSOR MODULE WITH I2C INTERFAC Rev. 1.1 12/14

More results

类似说明 - SI1141

制造商	部件名	数据表	功能描述
Silicon Laboratories	SI1153-AB9X-GMR	918Kb / 61P	Proximity/Ambient Light Sensor IC with I2C Interface Rev. 1.3
	SI115X	1Mb / 65P	Proximity/Ambient Light Sensor IC with I2C Interface Rev. 1.4
	SI1153	1Mb / 58P	Proximity/Ambient Light Sensor IC with IC Interface
	SI1143-M01-GMR	1Mb / 79P	PROXIMITY/AMBIENT LIGHT SENSOR MODULE WITH I2C INTERFACE Rev. 1.1 12/14
Everlight Electronics C...	EAAPMST3923A3	726Kb / 23P	Ambient Light Sensor and Proximity Sensor with I2C Interface
Everlight Electronics C...	EAAPMST3923A2	836Kb / 20P	Ambient Light Sensor and Proximity Sensor with I2C Interface
Silicon Laboratories	SI1141-A11-GM	1Mb / 77P	PROXIMITY/AMBIENT LIGHT SENSOR IC WITH I 2C INTERFACE Rev. 1.42 3/21
ON Semiconductor	NOA1302	226Kb / 9P	Ambient Light Sensor with I2C Interface August, 2009 ??Rev. 1
ON Semiconductor	LV0104CS	225Kb / 9P	Ambient Light Sensor, I2C Interface April 2015- Rev. 2
AMIC Technology	ASR8601	40Kb / 1P	Ambient Light Sensor with I2C digital interface