数据搜索系统,热门电子元器件搜索 |
|
74CB3Q16244DLRG4 数据表(PDF) 5 Page - Texas Instruments |
|
74CB3Q16244DLRG4 数据表(HTML) 5 Page - Texas Instruments |
5 / 15 page www.ti.com Electrical Characteristics (1) Switching Characteristics SN74CB3Q16244 16-BIT FET BUS SWITCH 2.5-V/3.3-V LOW-VOLTAGE HIGH-BANDWIDTH BUS SWITCH SCDS168 – MAY 2004 – REVISED MARCH 2005 over recommended operating free-air temperature range (unless otherwise noted) PARAMETER TEST CONDITIONS MIN TYP(2) MAX UNIT VIK VCC = 3.6 V, II = –18 mA –1.8 V IIN Control inputs VCC = 3.6 V, VIN = 0 to 5.5 V ±1 µA VO = 0 to 5.5 V, Switch OFF, IOZ(3) VCC = 3.6 V, ±1 µA VI = 0, VIN = VCC or GND Ioff VCC = 0, VO = 0 to 5.5 V, VI = 0 1 µA II/O = 0, ICC VCC = 3.6 V, VIN = VCC or GND 1 2 mA Switch ON or OFF, ∆I CC (4) Control inputs VCC = 3.6 V, One input at 3 V, Other inputs at VCC or GND 30 µA Per control A and B ports open, mA/ ICCD(5) VCC = 3.6 V, 0.15 0.25 input Control input switching at 50% duty cycle MHz Cin Control inputs VCC = 3.3 V, VIN = 5.5 V, 3.3 V, or 0 3.5 5 pF Switch OFF, Cio(OFF) VCC = 3.3 V, VI/O = 5.5 V, 3.3 V, or 0 4 6 pF VIN = VCC or GND, Switch ON, Cio(ON) VCC = 3.3 V, VI/O = 5.5 V, 3.3 V, or 0 10 13 pF VIN = VCC or GND, VI = 0, IO = 30 mA 6 8 VCC = 2.3 V, TYP at VCC = 2.5 V VI = 1.7 V, IO = –15 mA 5 10 ron(6) Ω VI = 0, IO = 30 mA 6 8 VCC = 3 V VI = 2.4 V, IO = –15 mA 5 9 (1) VIN and IIN refer to control inputs. VI, VO, II, and IO refer to data pins. (2) All typical values are at VCC = 3.3 V (unless otherwise noted), TA = 25°C. (3) For I/O ports, the parameter IOZ includes the input leakage current. (4) This is the increase in supply current for each input that is at the specified TTL voltage level, rather than VCC or GND. (5) This parameter specifies the dynamic power-supply current associated with the operating frequency of a single control input (see Figure 2). (6) Measured by the voltage drop between the A and B terminals at the indicated current through the switch. ON-state resistance is determined by the lower of the voltages of the two (A or B) terminals. over recommended operating free-air temperature range (unless otherwise noted) (see Figure 3) VCC = 2.5 V VCC = 3.3 V FROM TO ± 0.2 V ± 0.3 V PARAMETER UNIT (INPUT) (OUTPUT) MIN MAX MIN MAX fOE(1) OE A or B 10 20 MHz tpd(2) A or B B or A 0.18 0.3 ns ten OE A or B 1.5 8 1.5 7 ns tdis OE A or B 1 8 1 7 ns (1) Maximum switching frequency for control input (VO > VCC, VI = 5 V, RL ≥ 1 MΩ, CL = 0) (2) The propagation delay is the calculated RC time constant of the typical ON-state resistance of the switch and the specified load capacitance, when driven by an ideal voltage source (zero output impedance). 5 |
类似零件编号 - 74CB3Q16244DLRG4 |
|
类似说明 - 74CB3Q16244DLRG4 |
|
|
链接网址 |
隐私政策 |
ALLDATASHEETCN.COM |
ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |