数据搜索系统,热门电子元器件搜索 |
|
SS4003 数据表(PDF) 5 Page - Silicon Standard Corp. |
|
SS4003 数据表(HTML) 5 Page - Silicon Standard Corp. |
5 / 10 page www.SiliconStandard.com 5 of 10 SS4003 2/01/2005 Rev.1.01 2. Design Capacity (DCAP): The DCAP is the user-specified battery capacity and is programmed in the ROM. 3. Remaining Capacity (RCAP): RCAP counts up to the value of FCCAP during charge and counts down during discharge and self- discharge. RCAP is set to a predefined value if the pack voltage drops down to a predefined level. If RCAP is equal to the predefined value, RCAP keeps until voltage drops below the predefined level. To prevent overstatement of charge during periods of overcharge, RCAP stops incrementing when RCAP = FCCAP. 4. Cumulated Discharge Count (CDC): The Cumulated Discharge Count is used to record the usage of the battery which response to the life of battery. The CDC counts up during discharge independent of RCAP and can continue increasing after RCAP has decremented to 0. The CDC resets to 0 when CDC = FCCAP. Charge Counting Charge activity is detected based on a positive voltage on pin I. The voltage input at pin I is measured and converted into current through the sense resistor. If charge activity is detected, the SS4003 increases the RCAP. Charge actions increment the RCAP according to the cumulated charge counts. Discharge Counting Discharge activity is detected based on a negative voltage on pin I. The voltage input at pin I is measured and converted into current through the sense resistor. If discharge activity is detected, the SS4003 decreases the RCAP. Self-Discharge Estimation Because of the self-discharge, the SS4003 decrements RCAP periodically until the charge full or charge empty condition is detected. The estimated self-discharge rate is programmed in a ROM. Charge Control SS4003 utilizes PWM methodology for charge control. There are three types of charge control, trickle charge, constant current charge, and constant voltage charge. The SS4003 updates the charging current based on the battery’s voltage. The SS4003 uses current taper detection for Li-Ion primary charge termination and over voltage detection to suspend charging. The SS4003 also provides a number of safety terminations based on battery capacity, voltage, and conditions of individual cell. The PWM output control range is form 0% to 99%. Two types of control can be applied in typical applications. Application Circuit 2 shows a PWM to DC voltage conversion circuits that can be used in linear control applications. |
类似零件编号 - SS4003 |
|
类似说明 - SS4003 |
|
|
链接网址 |
隐私政策 |
ALLDATASHEETCN.COM |
ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |