数据搜索系统,热门电子元器件搜索 |
|
TSC2117 数据表(PDF) 9 Page - Texas Instruments |
|
|
TSC2117 数据表(HTML) 9 Page - Texas Instruments |
9 / 192 page (3) DAC to headphone-out PSRR measurement is calculated as Supp 10 DACOUT VSIG PSRR 20 log V é ù = ê ú ê ú ë û TSC2117 Low-Power Audio Codec With Embedded miniDSP, Stereo Class-D Speaker Amplifier, and Smart Four-Wire Touch-Screen Controller www.ti.com SLAS550A – APRIL 2009 – REVISED JUNE 2009 Electrical Characteristics (continued) At 25 °C, AVDD, HVDD, IOVDD, TSVDD, = 3.3 V, SLVDD, SRVDD = 3.6V, DVDD = 1.8 V, VREF = 3.3 V, f S (audio) = 48 kHz, CODEC_CLKIN = 256 × f S, PLL = Off, SAR input is AUX1, VOL/MICDET pin disabled (unless otherwise noted) PARAMETER TEST CONDITIONS MIN TYP MAX UNIT Microphone Bias Page 1/register 46, bits D1–D0 = 10 2.25 2.5 2.75 Voltage output V Page 1/register 46, bits D1–D0 = 01 2 At 4-mA load current, page 1/register 46, bits D1–D0 5 = 10 (MICBIAS = 2.5 V) Voltage regulation mV At 4-mA load current, page 1/register 46, bits D1–D0 7 = 01 (MICBIAS = 2 V) Audio ADC Digital Decimation Filter Characteristics See Section 5.5.4.4 for audio ADC decimation filter characteristics. DAC HEADPHONE OUTPUT, AC-coupled load = 16 Ω (single-ended), driver gain = 0 dB, parasitic capacitance = 30 pF Full-scale output voltage (0 Output common-mode setting = 1.65 V 0.707 Vrms dB) SNR Signal-to-noise ratio Measured as idle-channel noise, A-weighted(1)(2) 80 95 dB THD Total harmonic distortion 0-dBFS input –85 –65 dB Total harmonic distortion + THD+N 0-dBFS input –82 –60 dB noise Mute attenuation 87 dB PSRR Power-supply rejection ratio(3) Ripple on HVDD (3.3 V) = 200 mVp-p at 1 kHz 62 dB RL = 32 Ω, THD+N ≤ –60 dB 20 PO Maximum output power mW RL = 16 Ω, THD+N ≤ –60 dB 60 DAC LINEOUT (HP Driver in Lineout Mode) SNR Signal-to-noise ratio Measured as idle-channel noise, A-weighted 95 dB THD Total harmonic distortion 0-dBFS input, 0-dB gain –86 dB Total harmonic distortion + THD+N 0-dBFS input, 0-dB gain –82 dB noise DAC Digital Interpolation Filter Characteristics See Section 5.6.1.4 for DAC interpolation filter characteristics. DAC OUTPUT to CLASS-D SPEAKER OUTPUT; Load = 8 Ω (differential), 50 pF SLVDD = SRVDD = 3.6 V, BTL measurement, DAC input = 0 dBFS, DAC VCM (page 1/register 31, bits 2.2 D4–D3) = 1.65 V, class-D gain = 6 dB, THD ≤ –16.5 dB Output voltage Vrms SLVDD = SRVDD = 3.6 V, BTL measurement, DAC input = –2 dBFS, DAC VCM (page 1/register 31, bits 2.1 D4–D3) = 1.65 V, class-D gain = 6 dB, THD ≤ –20 dB SLVDD = SRVDD = 3.6 V, BTL measurement, DAC Output, common-mode input = mute, DAC VCM (page 1/register 31, bits 1.65 V D4–D3) = 1.65 V, class-D gain = 6 dB SLVDD = SRVDD = 3.6 V, BTL measurement, class-D gain = 6 dB, measured as idle-channel noise, SNR Signal-to-noise ratio 87 dB A-weighted (with respect to full-scale output value of 2.2 Vrms)(1)(2) (1) Ratio of output level with 1-kHz full-scale sine-wave input, to the output level with the inputs short-circuited, measured A-weighted over a 20-Hz to 20-kHz bandwidth using an audio analyzer. (2) All performance measurements done with 20-kHz low-pass filter and, where noted, A-weighted filter. Failure to use such a filter may result in higher THD+N and lower SNR and dynamic range readings than shown in the Electrical Characteristics. The low-pass filter removes out-of-band noise, which, although not audible, may affect dynamic specification values. Submit Documentation Feedback ELECTRICAL SPECIFICATIONS 9 |
类似零件编号 - TSC2117 |
|
类似说明 - TSC2117 |
|
|
链接网址 |
隐私政策 |
ALLDATASHEETCN.COM |
ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |