数据搜索系统,热门电子元器件搜索 |
|
SMJ4C1024-12HL 数据表(PDF) 4 Page - Texas Instruments |
|
SMJ4C1024-12HL 数据表(HTML) 4 Page - Texas Instruments |
4 / 27 page SMJ4C1024 1048576 BY 1-BIT DYNAMIC RANDOM-ACCESS MEMORY SGMS023E – DECEMBER 1988 – REVISED MARCH 1996 4 POST OFFICE BOX 1443 • HOUSTON, TEXAS 77251–1443 functional block diagram RAS CAS W Timing and Control Row Address Buffers (10) Column Address Buffers (10) A0 A1 A2 A3 A4 A5 A6 A7 A8 A9 256K Array Row Decode 256K Array Sense Amplifiers Sense Amplifiers 256K Array Row Decode 256K Array Column Decode I/O Buffers 1 of 8 Selection Data In Reg. Data Out Reg. D Q operation enhanced page mode Enhanced page-mode operation allows faster memory access by keeping the same row address while selecting random column addresses. The time for row-address setup and hold and for address multiplexing is eliminated. The maximum number of columns that can be accessed is determined by the maximum RAS low time and the CAS page-cycle time used. With minimum CAS page-cycle time, all 1 024 columns specified by column addresses A0 through A9 can be accessed without intervening RAS cycles. Unlike conventional page-mode DRAMs, the column-address buffers in this device are activated on the falling edge of RAS. The buffers act as transparent or flow-through latches while CAS is high. The falling edge of CAS latches the column addresses. This feature lets the SMJ4C1024 operate at a higher data bandwidth than conventional page-mode parts, since data retrieval begins as soon as the column address is valid rather than when CAS goes low. This performance improvement is referred to as enhanced page mode. A valid column address can be presented immediately after the row-address hold time has been satisfied, usually well in advance of the falling edge of CAS. In this case, data is obtained after ta(C) maximum (access time from CAS low) if ta(CA) maximum (access time from column address) has been satisfied. If the column addresses for the next page cycle are valid at the same time CAS goes high, access time for the next cycle is determined by the later occurrence of ta(CA) or ta(CP) (access time from rising edge of CAS). address (A0 – A9) Twenty address bits are required to decode one of 1 048 576 storage cell locations. Ten row-address bits are set up on inputs A0 through A9 and latched onto the chip by RAS. The ten column-address bits are set up on pins A0 through A9 and latched onto the chip by CAS. All addresses must be stable on or before the falling edges |
类似零件编号 - SMJ4C1024-12HL |
|
类似说明 - SMJ4C1024-12HL |
|
|
链接网址 |
隐私政策 |
ALLDATASHEETCN.COM |
ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |