![]() |
数据搜索系统,热门电子元器件搜索 |
|
ISL6219A_07 Datasheet(数据表) 4 Page - Intersil Corporation |
|
ISL6219A Datasheet(HTML) 4 Page - Intersil Corporation |
4 page ![]() 4 FN9093.1 March 20, 2007 Functional Pin Descriptions VID0, VID1, VID2, VID3, VID4 (Pins 1, 2, 3, 4, 5) These are the inputs to the internal DAC that provide the reference voltage for output regulation. Each pin has an internal 20 μA pull-up current source to 2.5V making the parts compatible with CMOS and TTL logic from 5V down to 2.5V. When a VID change is detected the reference voltage slowly ramps up or down to the new value in 25mV steps. Connect these pins to either open-drain or active-pull-up type outputs. Pulling these pins above 2.9V can cause a reference offset inaccuracy. FS/EN (Pin 7) This is a dual function pin. A resistor placed from FS/EN to ground sets the switching frequency. There is an inverse relationship between the value of the resistor and the switching frequency. This pin can also be used to disable the controller. To disable the controller, pull this pin below 1V. FB (Pin 8) and COMP (Pin 9) The internal error amplifier’s inverting input and output respectively. These pins are connected to an external R-C network to compensate the regulator. GND (Pin 14) Bias and signal ground for the IC. VSEN (Pin 15) Power good monitor input. Connect to the microprocessor CORE voltage. PWM3, PWM2, PWM1 (Pins 18, 21, 22) Pulse-width modulation outputs. These logic outputs tell the driver IC(s) when to turn the MOSFETs on and off. ISEN3, ISEN2, ISEN1 (PINS 19, 20, 23) Current sense inputs. A resistor connected between these pins and the respective phase nodes has a current proportional to the current in the lower MOSFET during its conduction interval. The current is used as a reference for channel balancing, load sharing, protection, and load-line regulation. PGOOD (Pin 25) Power good. This pin is an open-drain logic signal that indicates when the microprocessor CORE voltage (VSEN pin) is within specified limits and soft-start has timed out. VCC (Pin 28) Bias supply voltage for the controller. Connect this pin to a 5V power supply. ISL6219A |