数据搜索系统,热门电子元器件搜索 |
|
GS-R12P0001.5 数据表(PDF) 5 Page - STMicroelectronics |
|
GS-R12P0001.5 数据表(HTML) 5 Page - STMicroelectronics |
5 / 7 page 5/7 GS-R12P USER NOTES Input Voltage The recommended operating maximum DC Input Voltage is 15V inclusive of ripple voltage. Inhibit function The inhibit feature allows to put in stand-by mode the device. With INH pin 4 higher than 2.2V the device is disabled and the power consumption is reduced to less than 100µA for Vi = 15V. With INH pin lower than 0.8V, the device is enabled. If the INH pin is left floating, an internal pull up ensures that the voltage at the pin reaches the inhibit threshold and the device is disabled. The pin is also Vi compatible. Current protection The device has two current limit protections, pulse by pulse and frequency fold back. The current is sensed through a resistor and if reaches the threshold, the on time is reduced and consequently the output voltage too. Since the minimum switch ON time (necessary to avoid false overcurrent signal) is not enough to obtain a suf- ficiently low duty cycle at 250 Hz, the output current, in strong overcurrent or short circuit conditions, could in- crease again. For this reason the switching frequency is also reduced, so keeping the inductor current under its maximum threshold. The frequency depends on the feedback voltage. As the feedback voltage decreases (due to the reduced duty cycle), the switching frequency decrease too. Thermal shutdown The shutdown block generates a signal that turns off the power stage if the temperature of the internal chip goes higher than a fixed internal threshold (150 ºC). The sensing element of the chip is very close to the PDMOS area, so ensuring an accurate and fast temperature detection. An hysteresis of approximately 20ºC avoids that the devices turns on and off continuously. Thermal Characteristics Output voltage programming (GS-R12H(S)0001.5 only) The GS-R12P output voltage is 5.54V ±4%, to reduce this value connect a resistor between pin 6 (FB) and pin 5 (Vout-c). The resistor must be located very close to the proper pins, to minimize the injected noise (see figure 1). The resistor value is calculated using the following formula: Rv=[(Vout-1.235)*11.3]/(5.54-Vout) --[kOhm] Vout can be adjusted between 1.235V (Rv=0 Ohm) and 5.54V (Rv=open) |
类似零件编号 - GS-R12P0001.5 |
|
类似说明 - GS-R12P0001.5 |
|
|
链接网址 |
隐私政策 |
ALLDATASHEETCN.COM |
ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |