4. Part of the leader and part of the vacant section are attached as follows.

The sprocket holes are to the right as the tape is pulled toward the user.

5. Accumulate tolerance of sprocket holes pitch = +/-0.3mm/10 pitch

6. Chip in the tape is enclosed as shown in 2.Dimensions of Tape.

7. The top tape and carrier tape are not attached at the end of the tape for a minimum of 5 pitches.

8. There are no jointing for top tape and bottom tape.

9. There are no fuzz in the cavity.

10. Break down force of top tape : 5N min.

Break down force of bottom tape : 5N min. (Only a bottom tape existence )

11. Reel is made by resin and appeaser and dimension is shown in 3.Dimensions of Reel.

　

There are possibly to change the material and dimension due to some impairment.

12. Peeling off force :

0.1N to 0.6N

in the direction as shown below.

13. Label that show the customer parts number, our parts number, our company name, inspection

number and quantity, will be put in outside of reel.

図1 ﾁｯﾌﾟ詰め状態

(単位：mm)

165° to 180°

Top tape

図1 ﾁｯﾌﾟ詰め状態

(単位：mm)

Tail vacant Section

Chip-mounting Unit

Leader vacant Section

Leader Unit

(Top Tape only)

Direction

of Feed

160 min.

190 min.

210 min.

　

GRM1885C2A101JA01-01A