2

f1

2

f6

2

f2

10

‡

A

A

+

+

A

log

THD = 20

ADC088S022

www.ti.com

SNAS341F – SEPTEMBER 2005 – REVISED MARCH 2013

DIFFERENTIAL NON-LINEARITY (DNL) is the measure of the maximum deviation from the ideal step size of 1

LSB.

DUTY CYCLE is the ratio of the time that a repetitive digital waveform is high to the total time of one period. The

specification here refers to the SCLK.

EFFECTIVE NUMBER OF BITS (ENOB, or EFFECTIVE BITS) is another method of specifying Signal-to-Noise

and Distortion or SINAD. ENOB is defined as (SINAD - 1.76) / 6.02 and says that the converter is equivalent to a

perfect ADC of this (ENOB) number of bits.

FULL POWER BANDWIDTH is a measure of the frequency at which the reconstructed output fundamental

drops 3 dB below its low frequency value for a full scale input.

FULL SCALE ERROR (FSE) is a measure of how far the last code transition is from the ideal 1½ LSB below

(1)

LSB or percent of full scale range.

LSB), after adjusting for offset error.

INTEGRAL NON-LINEARITY (INL) is a measure of the deviation of each individual code from a line drawn from

negative full scale (½ LSB below the first code transition) through positive full scale (½ LSB above the last code

transition). The deviation of any given code from this straight line is measured from the center of that code value.

INTERMODULATION DISTORTION (IMD) is the creation of additional spectral components as a result of two

sinusoidal frequencies being applied to an individual ADC input at the same time. It is defined as the ratio of the

power in both the second or the third order intermodulation products to the power in one of the original

MISSING CODES are those output codes that will never appear at the ADC outputs. These codes cannot be

reached with any input value. The ADC088S022 is ensured not to have any missing codes.

OFFSET ERROR is the deviation of the first code transition (000...000) to (000...001) from the ideal (i.e. GND +

0.5 LSB).

SIGNAL TO NOISE RATIO (SNR) is the ratio, expressed in dB, of the rms value of the input signal to the rms

value of the sum of all other spectral components below one-half the sampling frequency, not including

harmonics or d.c.

SIGNAL TO NOISE PLUS DISTORTION (S/N+D or SINAD) Is the ratio, expressed in dB, of the rms value of the

input signal to the rms value of all of the other spectral components below half the clock frequency, including

harmonics but excluding d.c.

SPURIOUS FREE DYNAMIC RANGE (SFDR) is the difference, expressed in dB, between the rms values of the

input signal and the peak spurious signal where a spurious signal is any signal present in the output spectrum

that is not present at the input, including harmonics but excluding d.c.

TOTAL HARMONIC DISTORTION (THD) is the ratio, expressed in dBc, of the rms total of the first five harmonic

components at the output to the rms level of the input signal frequency as seen at the output. THD is calculated

as

(2)

first 5 harmonic frequencies.

THROUGHPUT TIME is the minimum time required between the start of two successive conversions. It is the

acquisition time plus the conversion and read out times. In the case of the ADC088S022, this is 16 SCLK

periods.

Copyright © 2005–2013, Texas Instruments Incorporated

Submit Documentation Feedback

7

Product Folder Links: ADC088S022