TS1105-20ITD833 datasheet(5/19 Pages) SILABS

部件名	TS1105-20ITD833

功能描述	Power Management Systems

Download	19 Pages

Scroll/Zoom	100%

制造商	SILABS [Silicon Laboratories]

网页	http://www.silabs.com

标志

5 / 19 page

2.3 Sign Output—TS1106 Only

The TS1106’s SIGN output indicates the load current’s direction. The SIGN output is a logic HIGH when M1 is conducting current (VRS

+ > VRS–). Alternatively, the SIGN output is a logic LOW when M2 is conducting current (VRS– > VRS+). The SIGN comparator’s

transfer characteristic is illustrated in the figure below. Unlike other current-sense amplifiers that implement an OUT/SIGN arrangement,

the TS1106 exhibits no “dead zone” at ILOAD switchover

Figure 2.3. TS1106 Sign Output Transfer Characteristic

2.4 Selecting a Sense Resistor

Selecting the optimal value for the external RSENSE is based on the following criteria, and commentary follows for each:

1. RSENSE Voltage Loss

2. VOUT Swing vs. Desired VSENSE and Applied Supply Voltage at VDD

3. Total ILOAD Accuracy

4. Circuit Efficiency and Power Dissipation

5. RSENSE Kelvin Connections

2.4.1 RSENSE Voltage Loss

For lowest IR power dissipation in RSENSE, the smallest usable resistor value for RSENSE should be selected.

2.4.2 VOUT Swing vs. Desired VSENSE and Applied Supply Voltage at VDD

Although the Current Sense Amplifier draws its power from the voltage at its RS+ and RS– terminals, the signal voltage at the OUT

terminal is provided by a buffer, and is therefore bounded by the buffer’s output range. As shown in the Electrical Characteristics table,

the CSA Buffer has a maximum and minimum output voltage of:

VOUT (max ) = VDD(min ) − 0.2V

VOUT (min ) = 0.2V

Therefore, the full-scale sense voltage should be chosen so that the OUT voltage is neither greater nor less than the maximum and

minimum output voltage defined above. To satisfy this requirement, the full-scale sense voltage, VSENSE(max), should be chosen so

that:

VSENSE(max ) <

VBIAS − VOUT (min )

GAIN

For best performance, RSENSE should be chosen so that the full-scale VSENSE is less than ±75 mV.

TS1105/06 Data Sheet

System Overview

silabs.com | Smart. Connected. Energy-friendly.

Rev. 1.0 | 4

类似零件编号 - TS1105-20ITD833

制造商	部件名	数据表	功能描述
STMicroelectronics	TS110-7	178Kb / 10P	High surge voltage 1.25 A SCR for circuit breaker June 2014 Rev 4
STMicroelectronics	TS110-8	228Kb / 10P	High surge voltage 1.25 A SCR for circuit breaker October 2014 Rev 1
Touchstone Semiconducto...	TS1100	771Kb / 11P	A 1uA, 2V to 25V SOT23 Precision Current-Sense Amplifier
Silicon Laboratories	TS1100	1Mb / 6P	Current Sense Amplifier Performance Comparison
Silicon Laboratories	TS1100	1Mb / 20P	High Side Bidirectional and Unidirectional Current Sense Amplifier

制造商	部件名	数据表	功能描述
Silicon Laboratories	TS1107	1Mb / 22P	Power Management Systems
Silicon Laboratories	TS1103	1Mb / 12P	Power Management Systems
Shenzhen Guan Hua Wei Y...	WSK140N06	1Mb / 6P	Power Management for Inverter Systems.
Texas Instruments	TPS65020	3Mb / 44P	[Old version datasheet] POWER MANAGEMENT IC FOR LI-ION POWERED SYSTEMS
	TPS65021	2Mb / 45P	[Old version datasheet] POWER MANAGEMENT IC FOR LI-ION POWERED SYSTEMS
	TPS65023	908Kb / 43P	[Old version datasheet] POWER MANAGEMENT IC FOR LI-ION POWERED SYSTEMS
STMicroelectronics	STPM066S	877Kb / 67P	Power management for automotive vision and radar systems Rev 2 - February 2023
Texas Instruments	TPS65023	1Mb / 55P	[Old version datasheet] POWER MANAGEMENT IC FOR LI-ION POWERED SYSTEMS
Texas Instruments	TPS65023-Q1	1Mb / 50P	[Old version datasheet] Power Management IC For Li-Ion Powered Systems
Skyworks Solutions Inc.	SKY87020-11	181Kb / 2P	Power Management IC for SkyOne Ultra 2.0 Systems