1

Dual, 128-Tap, Low Voltage Digitally Controlled

Potentiometer (XDCP™)

ISL23328

The ISL23328 is a volatile, low voltage, low noise, low power,

128-Tap, dual digitally controlled potentiometer (DCP) with an

and control logic on a monolithic CMOS integrated circuit.

Each digitally controlled potentiometer is implemented with a

combination of resistor elements and CMOS switches. The

bus interface. Each potentiometer has an associated volatile

Wiper Register (WRi, i = 0, 1) that can be directly written to and

read by the user. The contents of the WRi controls the position

of the wiper. When powered on, the wiper of each DCP will

always commence at mid-scale (64 tap position).

The low voltage, low power consumption, and small package

of the ISL23328 make it an ideal choice for use in battery

pin allowing down to 1.2V bus operation, independent from the

directly to the ISL23328 without passing through a voltage

level shifter.

The DCP can be used as a three-terminal potentiometer or as a

two-terminal variable resistor in a wide variety of applications

including control, parameter adjustments, and signal

processing.

Applications

• Power supply margining

• Trimming sensor circuits

• Gain adjustment in battery powered instruments

• RF power amplifier bias compensation

Features

• Two potentiometers per package

•128 resistor taps

•10kΩ, 50kΩ or 100kΩ total resistance

- No additional level translator for low bus supply

- Three address pins allow up to eight devices per bus

•Power supply

• Maximum supply current without serial bus activity

(standby)

•Shutdown Mode

- Forces the DCP into an end-to-end open circuit and RWi is

connected to RLi internally

- Reduces power consumption by disconnecting the DCP

resistor from the circuit

• Power-on preset to mid-scale (64 tap position)

• 14 Ld TSSOP or 16 Ld UTQFN packages

• Pb-free (RoHS Compliant)

FIGURE 1. FORWARD AND BACKWARD RESISTANCE vs TAP

POSITION, 10kΩ DCP

0

2000

4000

6000

8000

10000

032

64

96

128

TAP POSITION (DECIMAL)

ISL28114

1 DCP

OF

ISL23328

+

-

RL1

RW1

RH1

September 29, 2015

FN7902.1

CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.

1-888-INTERSIL or 1-888-468-3774 | Copyright Intersil Americas LLC 2011, 2015. All Rights Reserved

Intersil (and design) and XDCP are trademarks owned by Intersil Corporation or one of its subsidiaries.

All other trademarks mentioned are the property of their respective owners.