ADC102S101

SNAS287G – FEBRUARY 2005 – REVISED MARCH 2013

www.ti.com

Specification Definitions

ACQUISITION TIME is the time required to acquire the input voltage. That is, it is time required for the hold

capacitor to charge up to the input voltage.

APERTURE DELAY is the time between the fourth falling SCLK edge of a conversion and the time when the

input signal is acquired or held for conversion.

CONVERSION TIME is the time required, after the input voltage is acquired, for the ADC to convert the input

voltage to a digital word.

CROSSTALK is the coupling of energy from one channel into the other channel, or the amount of signal energy

from one analog input that appears at the measured analog input.

DIFFERENTIAL NON-LINEARITY (DNL) is the measure of the maximum deviation from the ideal step size of 1

LSB.

DUTY CYCLE is the ratio of the time that a repetitive digital waveform is high to the total time of one period. The

specification here refers to the SCLK.

EFFECTIVE NUMBER OF BITS (ENOB, or EFFECTIVE BITS) is another method of specifying Signal-to-Noise

and Distortion or SINAD. ENOB is defined as (SINAD

− 1.76) / 6.02 and says that the converter is equivalent to

a perfect ADC of this (ENOB) number of bits.

FULL POWER BANDWIDTH is a measure of the frequency at which the reconstructed output fundamental

drops 3 dB below its low frequency value for a full scale input.

FULL SCALE ERROR (FSE) is a measure of how far the last code transition is from the ideal 1½ LSB below

where

•

or percent of full scale range.

(1)

LSB), after adjusting for offset error.

INTEGRAL NON-LINEARITY (INL) is a measure of the deviation of each individual code from a line drawn from

negative full scale (½ LSB below the first code transition) through positive full scale (½ LSB above the last code

transition). The deviation of any given code from this straight line is measured from the center of that code value.

INTERMODULATION DISTORTION (IMD) is the creation of additional spectral components as a result of two

sinusoidal frequencies being applied to the ADC input at the same time. It is defined as the ratio of the power in

the second and third order intermodulation products to the sum of the power in both of the original frequencies.

IMD is usually expressed in dB.

MISSING CODES are those output codes that will never appear at the ADC outputs. These codes cannot be

reached with any input value. The ADC102S101 is guaranteed not to have any missing codes.

OFFSET ERROR is the deviation of the first code transition (000...000) to (000...001) from the ideal (i.e. GND +

0.5 LSB).

SIGNAL TO NOISE RATIO (SNR) is the ratio, expressed in dB, of the rms value of the input signal at the

converter output to the rms value of the sum of all other spectral components below one-half the sampling

frequency, not including d.c. or harmonics included in the THD specification..

SIGNAL TO NOISE PLUS DISTORTION (S/N+D or SINAD) Is the ratio, expressed in dB, of the rms value of the

input signal to the rms value of all of the other spectral components below half the clock frequency, including

harmonics but excluding d.c.

SPURIOUS FREE DYNAMIC RANGE (SFDR) is the difference, expressed in dB, between the rms values of the

input signal and the peak spurious signal where a spurious signal is any signal present in the output spectrum

that is not present at the input, excluding d.c.

8

Submit Documentation Feedback

Copyright © 2005–2013, Texas Instruments Incorporated

Product Folder Links: ADC102S101