数据搜索系统,热门电子元器件搜索 |
|
SM312CVB 数据表(PDF) 4 Page - List of Unclassifed Manufacturers |
|
SM312CVB 数据表(HTML) 4 Page - List of Unclassifed Manufacturers |
4 / 6 page Diffuse Mode Alignment Object If the Alignment LED does not go OFF when the object is removed from the beam, the sensor is probably detecting light reflected from some background object. To remedy this problem: • Reduce the reflectivity of the background by painting the surface(s) flat-black, scuffing any shiny surface, or drilling a large hole, directly opposite the diffuse sensor. • Move the sensor closer to the object to be detected and reduce the Gain ad- justment. Rule of thumb for diffuse sensing: The distance to the nearest back- ground object should be at least three times the sensing distance. Note: • Light condition: sensor output is ON when there is no object in beam • Dark condition: sensor output is ON when there is an object in beam Retroreflective Mode Alignment Retro Target A highly reflective object may reflect enough light back to a retroreflective sensor to allow that object to slip through the beam, without being detected. This problem is called “proxing,” and the following methods may be used to correct it: • Position the sensor and retro target so the beam will not strike a shiny surface perpendicular to the sensor lens. • Reduce the Gain adjustment. • Add a polarizing filter (for model SM312LV). Note: • Light condition: sensor output is ON when there is no object in beam • Dark condition: sensor output is ON when there is an object in beam Convergent Mode Alignment Object Low Reflectivity Background The sensing energy of a convergent mode sensor is concentrated at the specified focus point. Convergent mode sensors are less sensitive to background reflections, compared with diffuse mode sensors. However, if background reflections are a problem: • Skew the sensor position at a 10° to 25° angle to eliminate direct reflections from shiny background surfaces. • Reduce the reflectivity of the background by painting the surface(s) flat-black, scuffing any shiny surface, or drilling a large hole, directly opposite the sensor. • Reduce the Gain adjustment. Note: • Light condition: sensor output is ON when there is no object in beam • Dark condition: sensor output is ON when there is an object in beam MINI-BEAM dc-Voltage Series 4 www.bannerengineering.com - tel: 763-544-3164 P/N 69943 rev. C |
类似零件编号 - SM312CVB |
|
类似说明 - SM312CVB |
|
|
链接网址 |
隐私政策 |
ALLDATASHEETCN.COM |
ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |