CAT22C10JI-30TE13 datasheet(8/10 Pages) CATALYST

部件名	CAT22C10JI-30TE13

功能描述	256-Bit Nonvolatile CMOS Static RAM

Download	10 Pages

Scroll/Zoom	100%

制造商	CATALYST [Catalyst Semiconductor]

网页	http://www.catalyst-semiconductor.com

标志

8 / 10 page

CAT22C10

8

Doc. No. 25018-0A 2/98 N-1

Recall

At anytime, except during a store operation, taking the

RECALL pin low will initiate a recall operation. This is

independent of the state of

CS, WE, or A0–A5. After the

RECALL pin has been held low for the duration of the

Recall Pulse Width (tRCP), the recall will continue inde-

pendent of any other inputs. During the recall, the entire

contents of the E2PROM array is transferred to the Static

RAM array. The first byte of data may be externally

accessed after the recalled data access time from end of

recall (tARC) is met. After this, any other byte may be

accessed by using the normal read mode.

If the

RECALL pin is held low for the entire Recall Cycle

time (tRCC), the contents of the Static RAM may be

immediately accessed by using the normal read mode.

A recall operation can be performed an unlimited num-

ber of times without affecting the integrity of the data.

The outputs I/O0–I/O3 will go into the high impedance

state as long as the

RECALL signal is held low.

Store

At any time, except during a recall operation, taking the

STORE pin low will initiate a store operation. This takes

place independent of the state of

CS, WE or A0–A5. The

STORE pin must be held low for the duration of the Store

Pulse Width (tSTP) to ensure that a store operation is

initiated. Once initiated, the

STORE pin becomes a

“Don’t Care”, and the store operation will complete its

transfer of the entire contents of the Static RAM array

into the E2PROM array within the Store Cycle time

(tSTC). If a store operation is initiated during a write cycle,

the contents of the addressed Static RAM byte and its

corresponding byte in the E2PROM array will be un-

known.

During the store operation, the outputs are in a high

impedance state. A minimum of 100,000 store opera-

tions can be performed reliably and the data written into

the E2PROM array has a minimum data retention time

of 10 years.

DATA PROTECTION DURING POWER-UP AND

POWER-DOWN

The CAT22C10 has on-chip circuitry which will prevent

a store operation from occurring when VCC falls below

3.0V typ. This function eliminates the potential hazard of

spurious signals initiating a store operation when the

system power is below 3.0V typ.

Figure 4. Recall Cycle Timing

5153 FHD F08

5153 FHD F07

Figure 5. Store Cycle Timing

CS

DATA I/O

RECALL

ADDRESS

DATA UNDEFINED

DATA VALID

HIGH-Z

tRCZ

tORC

tARC

tRCP

tRCC

STORE

DATA I/O

tSTZ

tOST

HIGH-Z

tSTP

tSTC

类似零件编号 - CAT22C10JI-30TE13

制造商	部件名	数据表	功能描述
Catalyst Semiconductor	CAT22C10JI-30-TE13	508Kb / 10P	256-Bit Nonvolatile CMOS Static RAM

More results

类似说明 - CAT22C10JI-30TE13

制造商	部件名	数据表	功能描述
ON Semiconductor	CAT22C10J-30	177Kb / 10P	256-Bit Nonvolatile CMOS Static RAM Doc. No. MD-1082, Rev. R
Catalyst Semiconductor	CAT22C10	508Kb / 10P	256-Bit Nonvolatile CMOS Static RAM
ON Semiconductor	CAT22C10LI-20	177Kb / 10P	256-Bit Nonvolatile CMOS Static RAM Doc. No. MD-1082, Rev. R
	CAT22C10	177Kb / 10P	256-Bit Nonvolatile CMOS Static RAM Doc. No. MD-1082, Rev. R
	CAT24C44	65Kb / 9P	256-Bit Serial Nonvolatile CMOS Static RAM Doc. No. MD-1083, Rev. T
	CAT24C44LI-G	61Kb / 9P	256-Bit Serial Nonvolatile CMOS Static RAM Doc. No. MD-1083, Rev. T
	CAT24C44J	61Kb / 9P	256-Bit Serial Nonvolatile CMOS Static RAM Doc. No. MD-1083, Rev. T
	CAT24C44W	61Kb / 9P	256-Bit Serial Nonvolatile CMOS Static RAM Doc. No. MD-1083, Rev. T
	CAT24C44V	67Kb / 9P	256-Bit Serial Nonvolatile CMOS Static RAM Doc. No. MD-1083, Rev. T
	CAT24C44P	61Kb / 9P	256-Bit Serial Nonvolatile CMOS Static RAM Doc. No. MD-1083, Rev. T