数据搜索系统,热门电子元器件搜索 |
|
TD350E 数据表(PDF) 8 Page - STMicroelectronics |
|
TD350E 数据表(HTML) 8 Page - STMicroelectronics |
8 / 17 page Functional description TD350E 8/17 Doc ID 018539 Rev 2 5 Functional description 5.1 Input The input is compatible with optocouplers or pulse transformers. The input is triggered by the signal edge and allows the use of a small-sized, low-cost pulse transformer. Input is active low (output is high when input is low) to ease the use of the optocoupler. When driven by a pulse transformer, the input pulse (positive and negative) width must be larger than the minimum pulse width tonmin. 5.2 Voltage reference A voltage reference is used to create accurate timing for the two-level turn-off with external resistor and capacitor. 5.3 Desaturation protection Desaturation protection ensures the protection of the IGBT in the event of overcurrent. When the DESAT voltage goes higher than 7 V, the output is driven low (with 2-level turn-off, if applicable). The FAULT output is activated. The FAULT state is exited at the next falling edge of IN input. A programmable blanking time is used to allow enough time for IGBT saturation. Blanking time is provided by an internal current source and external capacitor. DESAT input can also be used with an external comparator for overcurrent or overtemperature detection. 5.4 Active Miller clamp A Miller clamp allows the control of the Miller current during a high dV/dt situation and can eliminate the need for a negative supply voltage. During turn-off, the gate voltage is monitored and the clamp output is activated when gate voltage goes below 2 V (relative to GND). The clamp voltage is VL+3 V max for a Miller current up to 500 mA. The clamp is disabled when the IN input is triggered again. 5.5 Two-level turn-off The two-level turn-off is used to increase the reliability of the application. During turn-off, gate voltage can be reduced to a programmable level in order to reduce the IGBT current (in the event of overcurrent). This action prevents both dangerous overvoltage across the IGBT and RBSOA problems, especially at short-circuit turn-off. Turn-off (Ta) delay is programmable through an external resistor and capacitor for accurate timing. Turn-off delay (Ta) is also used to delay the input signal to prevent distortion of input pulse width. |
类似零件编号 - TD350E |
|
类似说明 - TD350E |
|
|
链接网址 |
隐私政策 |
ALLDATASHEETCN.COM |
ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |