 |
数据搜索系统，热门电子元器件搜索 |
|
|
数据搜索系统，热门电子元器件搜索 |
|
ISL59911IRZ-EVALZ 数据表(PDF) 4 Page - Intersil Corporation |
|
||||||||||||||||||||||||||||||
ISL59911IRZ-EVALZ 数据表(HTML) 4 Page - Intersil Corporation |
|
|
4 / 17 page  ISL59911 4 FN7548.0 September 2, 2011 IMPORTANT NOTE: All parameters having Min/Max specifications are guaranteed. Typ values are for information purposes only. Unless otherwise noted, all tests are at the specified temperature and are pulsed tests, therefore: TJ = TC = TA Absolute Maximum Ratings (TA = +25°C) Thermal Information V+ = V+R = V+G = V+B, V- = V-R = V-G = V-B = V-D Supply Voltage between V+ and V-. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12V Maximum Absolute Slew Rate of V+ and V- . . . . . . . . . . . . . . . . . . . ±1V/µs Maximum Continuous Output Current per Channel . . . . . . . . . . . . . ±30mA Power Dissipation. . . . . . . . . . . . . . . . See “Power Dissipation” on page 12 Pin Voltages. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . V- - 0.5V to V+ + 0.5V ESD Ratings Human Body Model (tested per JESD22-A114) . . . . . . . . . . . . . . . 7000V Machine Model (Tested per JESD22-A115). . . . . . . . . . . . . . . . . . . . 300V Charged Device Model (Tested per JESD22C101C) . . . . . . . . . . . . 2000V Latch Up (Tested per JESD78; Class II, Level A) . . . . . . . . . . . . . . . . . . . . 100mA Thermal Resistance (Typical) θJA (°C/W) θJC (°C/W) 32 Ld QFN (Notes 5, 6) . . . . . . . . . . . . . . . . 31 2.1 Storage Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .-65°C to +150°C Die Junction Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .+150°C Pb-Free Reflow Profile . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . see link below http://www.intersil.com/pbfree/Pb-FreeReflow.asp Operating Conditions Temperature Range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -40°C to +85°C V+ Supply Range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4.5V to 5.5V V- Supply Range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -4.5V to -5.5V CAUTION: Do not operate at or near the maximum ratings listed for extended periods of time. Exposure to such conditions may adversely impact product reliability and result in failures not covered by warranty. NOTES: 5. θJA is measured in free air with the component mounted on a high effective thermal conductivity test board with “direct attach” features. See Tech Brief TB379. 6. For θJC, the “case temp” location is the center of the exposed metal pad on the package underside. Electrical Specifications V+ = V+R = V+G = V+B = +5V, V- = V-R = V-G = V-B = V-D = -5V, TA = +25°C, all registers at default settings (equalizer stages set to minimum boost, noise filter set to max bandwidth, x2 gain mode, GAINDC = 0dB), all analog inputs at 0V, auto offset calibration executed, RL = 5pF || (75Ω + 75Ω) to GND, thermal pad connected to -5V, unless otherwise specified. PARAMETER DESCRIPTION CONDITIONS MIN (Note 7) TYP MAX (Note 7) UNIT POWER SUPPLY Positive Supply Voltage (V+) V+ = V+R = V+G = V+B 4.5 5.5 V Negative Supply Voltage (V-) V- = V-R = V-G = V-B = V-D -4.5 -5.5 V Operating Current (ID+) Sum of currents into all V+ pins 110 140 mA Operating Current (ID-) Sum of currents out of all V- pins, including thermal pad 105 130 mA Disabled Current (ID+DISABLED) Sum of currents into all V+ pins ENABLE = 0V 2.5 3.5 mA Disabled Current (ID-DISABLED) Sum of currents into all V- pins, including thermal pad ENABLE = 0V 0.35 2.5 mA PSRRDC Power Supply Rejection Ratio 55 dB AC PERFORMANCE BW Full Power Bandwidth 250 MHz GAIN100MHz Maximum Boost @ 100MHz All three 100MHz filters set to maximum 26 dB GAIN20MHz Maximum Boost @ 20MHz 20MHz filter set to maximum 9.5 dB GAIN6MHz Maximum Boost @ 6MHz 6MHz filter set to maximum 7.5 dB GAIN1MHz Maximum Boost @ 1MHz 1MHz filter set to maximum 3.1 dB GAIN0.2MHz Maximum Boost @ 200kHz 200kHz filter set to maximum 0.75 dB GAINDC DC Gain Adjustment Range ±4 dB fNOISE_MIN -3dB Corner Freq of Noise Filter, High Noise Filter Register = 0x0 250 MHz fNOISE_MAX -3dB Corner Freq of Noise Filter, Low Noise Filter Register = 0xF 50 MHz SRDIFF Output Slew Rate VIN = -1V to +1V 1 V/ns THD Total Harmonic Distortion f = 10MHz, 0.7VP-P input sine wave -45 -60 dBc |
类似零件编号 - ISL59911IRZ-EVALZ |
|
类似说明 - ISL59911IRZ-EVALZ |
|
|
|
链接网址 |
| 隐私政策 |
| ALLDATASHEETCN.COM |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |
Chinese ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
