LC87F7DC8A

No.A1156-5/26

Continued from preceding page.

• HOLD mode: Suspends instruction execution and the operation of the peripheral circuits.

1) The CF, RC, X’tal, and frequency variable RC oscillators automatically stop operation.

2) There are three ways of resetting the HOLD mode.

(1) Setting the reset pin to the low level

(2) Setting at least one of the INT0, INT1, INT2, INT4, and INT5 pins to the specified level

(3) Having an interrupt source established at port 0

• X'tal HOLD mode: Suspends instruction execution and the operation of the peripheral circuits except the base timer

and the remote control receiver circuit.

1) The CF, RC, and frequency variable RC oscillators automatically stop operation.

2) The state of crystal oscillation established when the X'tal HOLD mode is entered is retained.

3) There are five ways of resetting the X'tal HOLD mode.

(1) Setting the reset pin to the low level

(2) Setting at least one of the INT0, INT1, INT2, INT4, and INT5 pins to the specified level

(3) Having an interrupt source established at port 0

(4) Having an interrupt source established in the base timer circuit

(5) Having an interrupt source established in the remote control receiver circuit

On-chip Debugger

• Supports software debugging with the IC mounted on the target board.

Package Form

• QIP100E(14×20): Lead-free type

• TQFP100(14×14): Lead-free type (Development)

Development Tools

• On-chip debugger: TCB87-TypeB + LC87F7DC8A

Flash ROM Programming Boards

Package

Programming boards

QIP100E(14

×20)

W87FQ100

TQFP100(14

×14)

W87FSQ100

Flash ROM Programmer

Maker

Model

Supported version

Device

Single

AF9708

AF9709/AF9709B/AF9709C

(Including product of Ando

Electric Co., Ltd)

(Note 2)

LC87F7DC8A

AF9723/AF9723B(Main body)

(Including product of Ando

Electric Co., Ltd)

(Note 2)

Flash Support Group, Inc.

(FSG)

Gang

AF9833(Unit)

(Including product of Ando

Electric Co., Ltd)

(Note 2)

LC87F7DC8A

AF9101/AF9103(Main body)

(FSG)

Flash Support Group, Inc.

(FSG)

+

SANYO (Note 1)

Onboard

Single/Gang

SIB87(interface driver)

(SANYO)

(Note 2)

LC87F7DC8A

Single/Gang

SKK/SKK Type B

(SANYO FWS)

SANYO

Onboard

Single/Gang

SKK-DBG Type B

(SANYO FWS)

Application Version

After 1.04

Chip Data Version

After 2.16

LC87F7DC8A

Note 1: With the FSG onboard programmer (AF9101/AF9103) and the serial interface driver provided by SANYO,

PC-less standalone onboard programming is possible

Note 2: Depending on programming conditions, it is necessary to use a dedicated programming device and a program.

Please contact SANYO or FSG if you have any questions or difficulties regarding this matter.