 |
数据搜索系统，热门电子元器件搜索 |
|
|
数据搜索系统，热门电子元器件搜索 |
|
ST20C2 数据表(PDF) 8 Page - STMicroelectronics |
|
||||||||||||||||||||||||||||||
ST20C2 数据表(HTML) 8 Page - STMicroelectronics |
|
|
8 / 212 page  ® 8/212 This section also describes any situations where the operation of the instruction is undefined or invalid. Example Using the add instruction as an example again, the comments listed are: Comments: Secondary instruction. This says that add is a secondar y instruction. 1.7 Notation The following sections give a full description of the notation used in the ‘definition’ section of the instruction descriptions. 1.7.1 The processor state The processor state consists of the registers (mainly Areg, Breg, Creg, Iptr, and Wptr), the contents of memory, and various flags and special registers (such as the error flags , process queue pointers, clock registers, etc.). The Wptr register is used for the address of the workspace of the current process. This address is word aligned and therefore has the two least significant bits set to zero. Wdesc is used for the ‘process descriptor’ — the value that is held in memory as an identifier of the process when the process is not being executed. This value is composed of the top 31 bits of the Wptr plus the process priority stored in bit 0 of the word. Bit 0 is set to 0 for high priority processes and 1 for low priority processes. Bit 1 of the process descriptor is always 0. 1.7.2 General The instruction descriptions are not intended to describe the way the instructions are implemented, but only their effect on the state of the processor. So, for example, the block move instructions are described in terms of a sequence of byte reads and writes even though the instructions are implemented to perform the minimum number of word reads and writes. Comments (in italics) are used to both clarify the description and to describe actions or values that cannot easily be represented by the notation used here; e.g. start next process. These actions may be performed in another subsystem in the device, such as the communications subsystem, and so any changes to machine state are not necessarily completely synchronized with the execution of the instruction (as the different subsystems work independently and in parallel). Ellipses are used to show a range of values; e.g. ‘i = 0..31’ means that i has values from 0 to 31, inclusive. |
类似零件编号 - ST20C2 |
|
类似说明 - ST20C2 |
|
|
链接网址 |
| 隐私政策 |
| ALLDATASHEETCN.COM |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |
Chinese ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
