数据搜索系统,热门电子元器件搜索
  Chinese  ▼
ALLDATASHEETCN.COM

X  

FM75 数据表(PDF) 11 Page - Fairchild Semiconductor

部件名 FM75
功能描述  Low-Voltage Two-Wire Digital Temperature Sensor with Thermal Alarm
Download  16 Pages
Scroll/Zoom Zoom In 100%  Zoom Out
制造商  FAIRCHILD [Fairchild Semiconductor]
网页  http://www.fairchildsemi.com
标志 FAIRCHILD - Fairchild Semiconductor

FM75 数据表(HTML) 11 Page - Fairchild Semiconductor

Back Button FM75 Datasheet HTML 7Page - Fairchild Semiconductor FM75 Datasheet HTML 8Page - Fairchild Semiconductor FM75 Datasheet HTML 9Page - Fairchild Semiconductor FM75 Datasheet HTML 10Page - Fairchild Semiconductor FM75 Datasheet HTML 11Page - Fairchild Semiconductor FM75 Datasheet HTML 12Page - Fairchild Semiconductor FM75 Datasheet HTML 13Page - Fairchild Semiconductor FM75 Datasheet HTML 14Page - Fairchild Semiconductor FM75 Datasheet HTML 15Page - Fairchild Semiconductor Next Button
Zoom Inzoom in Zoom Outzoom out
 11 / 16 page
background image
© 2006 Fairchild Semiconductor Corporation
www.fairchildsemi.com
FM75 Rev. 1.0.8
11
Serial Data Bus Operation
General Operation
Writing to and reading from the FM75 registers is accom-
plished via the SMBus-compatible two-wire serial inter-
face. SMBus protocol requires that one device on the
bus initiates and controls all read and write operations.
This device is called the “master” device. The master
device also generates the SCL signal, which is the clock
signal for all other devices on the bus. All other devices
on the bus are called “slave” devices. The FM75 is a
slave device. Both the master and slave devices can
send and receive data on the bus.
During SMBus operations, one data bit is transmitted per
clock cycle. All SMBus operations follow a repeating nine
clock-cycle pattern that consists of eight bits (one byte)
of transmitted data followed by an acknowledge (ACK) or
not acknowledge (NACK) from the receiving device.
Note that there are no unused clock cycles during any
operation—therefore there must be no breaks in the
stream of data and ACKs/NACKs during data transfers.
Conversely, too few clock cycles can lead to incorrect
operation if an inadvertent 8-bit read from a 16-bit regis-
ter occurs.
For most operations, SMBus protocol requires the SDA
line to remain stable (unmoving) whenever SCL is HIGH—
i.e., transitions on the SDA line can only occur when SCL
is LOW. The exceptions to this rule are when the master
device issues a start or stop signal. The slave device
cannot issue a start or stop signal.
Start Condition: This condition occurs when the SDA
line transitions from HIGH to LOW while SCL is HIGH.
The master device uses this condition to indicate that a
data transfer is about to begin.
Stop Condition: This condition occurs when the SDA
line transitions from LOW to HIGH while SCL is HIGH.
The master device uses this condition to signal the end
of a data transfer.
Acknowledge and Not Acknowledge: When data is
transferred to the slave device, it sends an acknowledge
(ACK) after receiving every byte of data. A master device
sends an acknowledge (ACK) following only the first byte
read from a two-byte register. The receiving device
sends an ACK by pulling SDA LOW for one clock cycle.
Following the last byte, a master device sends a “not
acknowledge” (NACK) followed by a stop condition. A
NACK is indicated by leaving SDA HIGH during the clock
after the last byte.
Slave Address
Each slave device on the bus has a unique 7-bit address
so the master can identify which device is sending or
receiving data.
The FM75 address is as follows:
The four MSBs of the FM75 address are hardwired to
1001. The three LSBs are user configurable by tying the
A0, A1, and A2 pins to either VDD or ground. This pro-
vides eight different FM75 addresses, which allows up to
eight FM75s to be connected to the same bus.
Writing to and Reading from the FM75
All read and write operations must begin with a start sig-
nal generated by the master device. After the start condi-
tion, the master device must immediately send a slave
address (7 bits), followed by a read/write bit. If the slave
address matches the address of the FM75, the FM75
sends an ACK after receiving the read/write bit by pulling
the SDA line LOW for one clock cycle. Figures 11 -16
provide timing diagrams for all FM75 operations.
Setting the Pointer
For all operations, the pointer stored in the command
register must be pointing to the register (temperature,
configuration, TOS or THYST) that is going to be written to
or read from. To change the pointer value in the com-
mand register, the read/write bit following the address
must be 0. This indicates that the master will write new
information into the command register.
After the FM75 sends an ACK in response to receiving
the address and read/write bit, the master device must
transmit an appropriate 8-bit pointer value, as explained
in the Registers section. The FM75 sends an ACK after
receiving the new pointer data.
The pointer set operation is illustrated in Figure 11. Any-
time a pointer set is performed, it must be immediately
followed by a read or write operation. Note that the six
MSBs of the pointer value must be zero. If the six MSBs
are not zero, the FM75 does not send an ACK and inter-
nally terminates the operation. The command register
retains the current pointer value between operations;
therefore, once a register is indicated, subsequent read
operations do not require a pointer set cycle. Write oper-
ations always require the pointer be reset.
1
0
0
1A1
A2
A0


类似零件编号 - FM75

制造商部件名数据表功能描述
logo
Fairchild Semiconductor
FM75 FAIRCHILD-FM75 Datasheet
532Kb / 15P
   Low Voltage 2-Wire Digital Temperature Sensor with Thermal Alarm
logo
SHENZHEN FUMAN ELECTRON...
FM7518 FUMAN-FM7518 Datasheet
397Kb / 7P
   PWM control power switch
FM7518A FUMAN-FM7518A Datasheet
401Kb / 7P
   PWM control power switch
FM7518B FUMAN-FM7518B Datasheet
401Kb / 7P
   PWM control power switch
logo
Formosa MS
FM751V-FL FORMOSA-FM751V-FL Datasheet
107Kb / 7P
   30mA Surface Mount Small Signal Schottky Diode- 40V
More results

类似说明 - FM75

制造商部件名数据表功能描述
logo
Fairchild Semiconductor
FM75 FAIRCHILD-FM75 Datasheet
532Kb / 15P
   Low Voltage 2-Wire Digital Temperature Sensor with Thermal Alarm
logo
List of Unclassifed Man...
ATS75 ETC2-ATS75 Datasheet
249Kb / 16P
   LOW- OLTAGE 2-WIRE DIGITAL TEMPERATURE SENSOR With Thermal Alarm
logo
Texas Instruments
LM75B TI-LM75B_15 Datasheet
1Mb / 31P
[Old version datasheet]   Digital Temperature Sensor and Thermal Watchdog With Two-Wire Interface
logo
Global Mixed-mode Techn...
G751 GMT-G751_05 Datasheet
257Kb / 12P
   Digital Temperature Sensor and Thermal Watchdog with Two-Wire Interface
logo
National Semiconductor ...
LM75 NSC-LM75 Datasheet
308Kb / 18P
   Digital Temperature Sensor and Thermal WATCHDOG with Two-Wire Interface
LM75 NSC-LM75_05 Datasheet
734Kb / 18P
   Digital Temperature Sensor and Thermal Watchdog with Two-Wire Interface
logo
Global Mixed-mode Techn...
G751-1P1 GMT-G751-1P1 Datasheet
268Kb / 11P
   Digital Temperature Sensor and Thermal Watchdog with Two-Wire Interface
G751 GMT-G751_15 Datasheet
63Kb / 1P
   Digital Temperature Sensor and Thermal Watchdog with Two-Wire Interface
logo
List of Unclassifed Man...
G751 ETC-G751 Datasheet
160Kb / 10P
   Digital Temperature Sensor and Thermal Watchdog with Two-Wire Interface
logo
Texas Instruments
LM75A TI1-LM75A Datasheet
1Mb / 21P
[Old version datasheet]   LM75A Digital Temperature Sensor and Thermal Watchdog with Two-Wire Interface
More results


Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16


数据表 下载

Go To PDF Page


链接网址




隐私政策
ALLDATASHEETCN.COM
ALLDATASHEET是否为您带来帮助?  [ DONATE ] 

关于 Alldatasheet   |   广告服务   |   联系我们   |   隐私政策   |   链接交换   |   制造商名单
All Rights Reserved©Alldatasheet.com


Mirror Sites
English : Alldatasheet.com  |   English : Alldatasheet.net  |   Chinese : Alldatasheetcn.com  |   German : Alldatasheetde.com  |   Japanese : Alldatasheet.jp
Russian : Alldatasheetru.com  |   Korean : Alldatasheet.co.kr  |   Spanish : Alldatasheet.es  |   French : Alldatasheet.fr  |   Italian : Alldatasheetit.com
Portuguese : Alldatasheetpt.com  |   Polish : Alldatasheet.pl  |   Vietnamese : Alldatasheet.vn
Indian : Alldatasheet.in  |   Mexican : Alldatasheet.com.mx  |   British : Alldatasheet.co.uk  |   New Zealand : Alldatasheet.co.nz
Family Site : ic2ic.com  |   icmetro.com