数据搜索系统,热门电子元器件搜索 |
|
MP1475 数据表(PDF) 7 Page - Monolithic Power Systems |
|
MP1475 数据表(HTML) 7 Page - Monolithic Power Systems |
7 / 16 page MP1475 – SYNCHRONOUS STEP-DOWN CONVERTER MP1475 Rev. 1.01 www.MonolithicPower.com 7 4/3/2014 MPS Proprietary Information. Patent Protected. Unauthorized Photocopy and Duplication Prohibited. © 2014 MPS. All Rights Reserved. PIN FUNCTIONS Package Pin # Name Description 1 PG Power Good Output. The output of this pin is an open drain that goes high if the output voltage exceeds 90% of the normal voltage. There is a 0.4ms delay between when FB≥90% to when the PG pin goes high. 2 IN Supply Voltage. The IN pin supplies power for internal MOSFET and regulator. The MP1475 operates from a +4.5V to +16V input rail. Requires a low-ESR, and low- inductance capacitor (C1) to decouple the input rail. Place the input capacitor very close to this pin and connect it with wide PCB traces and multiple vias to make the connection. 3 SW Switch Output. Connect this pin to the inductor and bootstrap capacitor. This pin is driven up to VIN by the high-side switch during the PWM duty cycle ON-time. The inductor current drives the SW pin negative during the OFF-time. The ON-resistance of the low-side switch and the internal body diode fixes the negative voltage. Connect using wide PCB traces and multiple vias. 4 GND System Ground. Reference ground of the regulated output voltage. PCB layout requires extra care. For best results connect to GND with copper and vias. 5 BST Bootstrap. Requires a capacitor connected between SW and BST pins is required to form a floating supply across the high-side switch driver. 6 EN/SYNC Enable. EN=high to enable the MP1475. Apply an external clock to change the switching frequency. For automatic start-up, connect EN pin to VIN with an 100kΩ resistor. 7 VCC Internal 5V LDO output. Powers the driver and control circuits are powered from this voltage. Decouple with a 0.1μF-0.22μF capacitor. Do not use a capacitor ≥0.22μF. 8 FB Feedback. Connect to the tap of an external resistor divider from the output to GND to set the output voltage. The frequency fold-back comparator lowers the oscillator frequency when the FB voltage is below 400mV to prevent current limit runaway during a short-circuit fault condition. Place the resistor divider as close to the FB pin as possible. Avoid placing vias on the FB traces. |
类似零件编号 - MP1475 |
|
类似说明 - MP1475 |
|
|
链接网址 |
隐私政策 |
ALLDATASHEETCN.COM |
ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |